Mauser Parts
|
Mauser
Corelite
Stocks
F-34 Designation is for sporter barrels.
F-54 Designation is for varmint barrels.
Mauser 98 F34 Black.....................................
$65.00 Add to cart 
Mauser 98 F54 Black......................................
$65.00 Add to cart
|
Corelite Series III
Mauser Stock
The Mauser stock from CoreLite Precision may be the most
convenient stock ever made for gunsmiths sporterizing surplus and
commercial Mauser rifle actions! The stock is available for two
different
barrel channels—F34 or F54. These barrel channels make the stock a
drop-in fit with pre-threaded Adams & Bennett barrels in those
contours. There's no barrel channel inletting required. Just drop your
barreled action into the stock, tighten the receiver's screws, and go
to the range! Fajen pioneered the development of stocks that were keyed
for a drop-in fit with pre-threaded, short chambered barrels—CoreLite
has pioneered the same concept in synthetic stocks! Available in Black
Synthetic . Note: If the original bolt handle
has been bent down or replaced, it wil be necessary to "rasp-in" a bolt
handle notch in the stock.
Available in Sporter (F34) & Varminter (F54) barrel channels
Fits most large ring Mauser rifles
Completely weatherproof
Front & rear swivel studs
Non-slip rubber buttpad
Weighs just 28 ounces
|
|
303
Enfield No1 Scope Mount
Fits .303 No.1, Mk. 3 (Does not fit .308) This .303 Enfield scope mount
is extremely stable and will hold zero. Black, T-6 aluminum. Great
hunting rifle. Install using weaver-type rings. No gunsmithing.
|
.303
Enfield No4 Scope Mount
Fits .303 No. 4, Mk. 1, 2, & 5. This .303 Enfield scope mount is
extremely stable and will hold zero. Black, T-6 aluminum. Great hunting
rifle. Install using weaver-type rings. No gunsmithing.
|
|
ATI
Mauser Bolt Handle
#MBH1800
Converts straight bolt or “wide-arc” bolt to bent bolt handle to
allow use of a scope. Fits all Mausers. Includes drill, tap, hardware
and installation instructions. Made of stainless steel in the USA.
|
ATI
Mauser Stock
with built in scope mount
Mauser 98 Stock with built-in scope mount rail. Replace the old wood
with an extremely durable stock made of black, glass-filled nylon. No
gunsmithing or modifications required. Built-in scope mount allows
multiple positions for rifle scopes. Sling swivel studs. Rubber butt
pad. Fits barrel diameter .950 to .990".
Fits 7mm/8mm, Large-ring, standard Bent-bolt, Mauser 98s. Partial
list includes German K-98s, Czech VZ-24s, Yugo 24/47s, Yugo 48/48As,
Turkish 1903/1937/1938/1946s, etc... Will NOT fit Large-Ring Swedish
M38/M96 6.5x55 or Small-Ring Mausers (Spanish M1916 .308). Must CONVERT
BOLT to fit straight bolt or "wide-arc" bolt. Straight bolt
or “wide-arc” bolt Mausers will need bolt bent or replaced.
|
Check out our
other great websites!
www.crazyfarmer.biz our sale page and uses paypal system.
|
